Cfs Distribute - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

cfs distribute

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
cfs distribute
To enable or disable Cisco Fabric Services (CFS) distribution on the switch, use the cfs distribute
command. To disable this feature, use the no form of the command.
Syntax Description
This command has no other arguments or keywords.
Command Default CFS distribution is enabled.
Command Modes Configuration mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines By default CFS is in the distribute mode. In the distribute mode, fabric-wide distribution is enabled.
Applications can distribute configuration data to all CFS-capable switches in the fabric where the
application exists. This is the normal mode of operation.
If you disable CFS distribution by entering the no cfs distribute command, the following events occur:
•
•
•
•
Examples
The following example shows how to disable CFS distribution:
switch(config)# no cfs distribute
The following example shows how to reenable CFS distribution:
switch(config)# cfs distribute
Related Commands Command
show cfs status
Cisco Nexus 5000 Series Command Reference
8-2
cfs distribute
no cfs distribute
Modification
This command was introduced.
The CFS commands continue to operate. However, CFS and the applications using CFS on the
switch are isolated from the rest of the fabric even though there is physical connectivity.
All CFS operations are restricted to the isolated switch.
CFS operations (for example, lock, commit, and abort) initiated at other switches do not have any
effect at the isolated switch.
CFS distribution is disabled over both Fibre Channel and IP.
Description
Displays whether CFS distribution is enabled or disabled.
Chapter 8 Fibre Channel Commands
OL-16599-01