Clear Spanning-Tree Counters - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

clear spanning-tree counters

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
clear spanning-tree counters
To clear the counters for the Spanning Tree Protocol (STP), use the clear spanning-tree counters
command.
Syntax Description interface
ethernet interface
port-channel channel
vlan vlan-id
Command Default None
Command Modes EXEC mode
Command History Release
4.0(0)N1(1a)
Usage Guidelines You can clear all the STP counters on the entire switch, per VLAN, or per interface.
Examples This example shows how to clear the STP counters for VLAN 5:
switch# clear spanning-tree counters vlan 5
Related Commands Command
show spanning-tree
Cisco Nexus 5000 Series Command Reference
2-14
clear spanning-tree counters [interface {ethernet interface | port-channel channel}] [vlan
vlan-id]
(Optional) Specifies the interface type.
Slot and port number.
EtherChannel number.
(Optional) Specifies the VLAN. The range is from 1 to 4094.
Modification
This command was introduced.
Description
Displays information about the spanning tree state.
Chapter 2 Ethernet Commands
OL-16599-01