Show Vlan Filter - Cisco AP775A - Nexus Converged Network Switch 5010 Command Reference Manual

show vlan filter

S e n d c o m m e n t s t o n x 5 0 0 0 - d o c f e e d b a c k @ c i s c o . c o m
show vlan filter
To display information about instances of the vlan filter command, including the VLAN access map and
the VLAN IDs affected by the command, use the show vlan filter command.
Syntax Description access-map map-name
vlan vlan-id
Command Default
All instances of VLAN access maps applied to a VLAN are displayed, unless you use the access-map
keyword and specify an access map or you use the vlan keyword and specify a VLAN ID.
Command Modes
EXEC mode
Command History
Release
4.0(0)N1(1a)
Examples This example shows how to display all VLAN access map information on the switch:
switch# show vlan filter
Related Commands Command
action
match
show vlan access-map
vlan access-map
vlan filter
Cisco Nexus 5000 Series Command Reference
6-126
show vlan filter [access-map map-name | vlan vlan-id]
(Optional) Limits the output to VLANs that the specified access map is
applied to.
(Optional) Limits the output to access maps that are applied to the specified
VLAN only.
Modification
This command was introduced.
Description
Specifies an action for traffic filtering in a VLAN access map.
Specifies an ACL for traffic filtering in a VLAN access map.
Displays all VLAN access maps or a VLAN access map.
Configures a VLAN access map.
Applies a VLAN access map to one or more VLANs.
Chapter 6 Security Commands
OL-16599-01