Configuring Module And Facility Messages Logging - Cisco Nexus 3548 Configuration Manual

Configuring System Message Logging
auth
authpriv
bootvar
callhome
capability
cdp
cert_enroll
...

Configuring Module and Facility Messages Logging

You can configure the severity level and time-stamp units of messages logged by modules and facilities.
Procedure
Step 1
Step 2
Step 3
0
3
5
2
2
2
2
Command or Action
switch# configure terminal
switch(config)# logging module
[severity-level]
switch(config)# logging level
facility severity-level
Cisco Nexus 3548 Switch NX-OS System Management Configuration Guide, Release 6.x
Configuring Module and Facility Messages Logging
0
3
5
2
2
2
2
Purpose
Enters global configuration mode.
Enables module log messages that have the specified severity
level or higher. Severity levels range from 0 to 7:
• 0 – emergency
• 1 – alert
• 2 – critical
• 3 – error
• 4 – warning
• 5 – notification
• 6 – informational
• 7 – debugging
If the severity level is not specified, the default of 5 is used.
Enables logging messages from the specified facility that have
the specified severity level or higher. Severity levels from 0 to
7:
• 0 – emergency
• 1 – alert
• 2 – critical
• 3 – error
• 4 – warning
• 5 – notification
• 6 – informational
• 7 – debugging
73