Logging Module - Cisco MDS 9124 - Fabric Switch Reference

logging module

S e n d d o c u m e n t a t i o n c o m m e n t s t o m d s f e e d b a c k - d o c @ c i s c o . c o m
logging module
To set message logging for linecards, use the logging module command. To negate the previously issued
command or to revert to factory defaults, use the no form of the command.
Syntax Description
severity-level
Defaults
None.
Command Modes Configuration mode.
Command History Release
1.0(2)
Usage Guidelines
None.
Examples The following example sets message logging for modules at level 7.
switch
switch(config)# logging module 7
Related Commands Command
show logging
Cisco MDS 9000 Family Command Reference
14-20
logging module [severity-level]
no logging module [severity-level]
Specifies the maximum severity of messages logged. The range is 0 to 7,
where 0 is emergency, 1 is alert, 2 is critical, 3 is error, 4 is warning, 5 is
notify, 6 is informational, and 7 is debugging.
Modification
This command was introduced.
#
# config terminal
Description
Displays logging configuration information.
Chapter 14
OL-16217-01, Cisco MDS SAN-OS Release 3.x
L Commands