Specifying The Mst Configuration Revision Number - Cisco nexus 5000 series Configuration Manual

Specifying the MST Configuration Revision Number

SUMMARY STEPS
1. switch# configure terminal
2. switch(config)# spanning-tree mst configuration
3. switch(config-mst)# name name
DETAILED STEPS
Command or Action
Step 1 switch# configure terminal
Step 2 switch(config)# spanning-tree mst
configuration
Step 3 switch(config-mst)# name name
This example shows how to set the name of the MST region:
switch# configure terminal
switch(config)# spanning-tree mst configuration
switch(config-mst)# name accounting
Specifying the MST Configuration Revision Number
You configure the revision number on the bridge. For two or more bridges to be in the same MST region,
they must have the identical MST name, VLAN-to-instance mapping, and MST revision number.
SUMMARY STEPS
1. switch# configure terminal
2. switch(config)# spanning-tree mst configuration
3. switch(config-mst)# revision version
DETAILED STEPS
Command or Action
Step 1
switch# configure terminal
Step 2
switch(config)# spanning-tree mst configuration
Step 3
switch(config-mst)# revision version
Cisco Nexus 5000 Series NX-OS Layer 2 Switching Configuration Guide, Release 5.1(3)N1(1)
198
Purpose
Enters global configuration mode.
Enters MST configuration submode.
Specifies the name for MST region. The name string has a
maximum length of 32 case-sensitive characters. The default is
an empty string.
Purpose
Enters global configuration mode.
Enters MST configuration submode.
Specifies the revision number for the MST region. The range
is from 0 to 65535, and the default value is 0.
Configuring Multiple Spanning Tree
OL-25842-01