Intel 6 SERIES CHIPSET - DATASHEET 01-2011 Datasheet page 769

PCI Express* Configuration Registers
19.1.22 BCTRL—Bridge Control Register
(PCI Express*—D28:F0/F1/F2/F3/F4/F5/F6/F7/F6/F7)
Address Offset: 3Eh–3Fh
Default Value:
Bit
15:12
11
10
9
8
7
6
5
4
3
2
1
0
Datasheet
0000h
Reserved
Discard Timer SERR# Enable (DTSE): Reserved per PCI Express* Base Specification,
Revision 1.0a
Discard Timer Status (DTS): Reserved per PCI Express* Base Specification, Revision
1.0a.
Secondary Discard Timer (SDT): Reserved per PCI Express* Base Specification,
Revision 1.0a.
Primary Discard Timer (PDT): Reserved per PCI Express* Base Specification, Revision
1.0a.
Fast Back to Back Enable (FBE): Reserved per PCI Express* Base Specification,
Revision 1.0a.
Secondary Bus Reset (SBR) — R/W. Triggers a hot reset on the PCI Express* port.
Master Abort Mode (MAM): Reserved per Express specification.
VGA 16-Bit Decode (V16) — R/W.
0 = VGA range is enabled.
1 = The I/O aliases of the VGA range (see BCTRL:VE definition below), are not enabled,
and only the base I/O ranges can be decoded.
VGA Enable (VE)— R/W.
0 = The ranges below will not be claimed off the backbone by the root port.
1 = The following ranges will be claimed off the backbone by the root port:
• Memory ranges A0000h-BFFFFh
• I/O ranges 3B0h – 3BBh and 3C0h – 3DFh, and all aliases of bits 15:10 in any combination of 1s
ISA Enable (IE) — R/W. This bit only applies to I/O addresses that are enabled by the
I/O Base and I/O Limit registers and are in the first 64 KB of PCI I/O space.
0 = The root port will not block any forwarding from the backbone as described below.
1 = The root port will block any forwarding from the backbone to the device of I/O
transactions addressing the last 768 bytes in each 1-KB block (offsets 100h to
3FFh).
SERR# Enable (SE) — R/W.
0 = The messages described below are not forwarded to the backbone.
1 = ERR_COR, ERR_NONFATAL, and ERR_FATAL messages received are forwarded to
the backbone.
Parity Error Response Enable (PERE) — R/W. When set,
0 = Poisoned write TLPs and completions indicating poisoned TLPs will not set the
SSTS.DPD (D28:F0/F1/F2/F3/F4/F5/F6/F7:1E, bit 8).
1 = Poisoned write TLPs and completions indicating poisoned TLPs will set the
SSTS.DPD (D28:F0/F1/F2/F3/F4/F5/F6/F7:1E, bit 8).
Attribute: R/W
Size: 16 bits
Description
769