Intel 6 SERIES CHIPSET - DATASHEET 01-2011 Datasheet page 713

®
Integrated Intel High Definition Audio Controller Registers
17.1.2.7 WAKEEN—Wake Enable Register
®
(Intel
Memory Address:HDBAR + 0Ch
Default Value:
Function Level Reset: No
Bit
15:4 Reserved.
SDIN Wake Enable Flags — R/W. These bits control which SDI signal(s) may
generate a wake event. A 1b in the bit mask indicates that the associated SDIN signal is
enabled to generate a wake.
Bit 0 is used for SDI[0]
Bit 1 is used for SDI[1]
3:0
Bit 2 is used for SDI[2]
Bit 3 is used for SDI[3]
NOTE: These bits are in the resume well and only cleared on a power on reset.
17.1.2.8 STATESTS—State Change Status Register
®
(Intel
Memory Address:HDBAR + 0Eh
Default Value:
Function Level Reset: No
Bit
15:4 Reserved.
SDIN State Change Status Flags — R/WC. Flag bits that indicate which SDI signal(s)
received a state change event. The bits are cleared by writing 1s to them.
Bit 0 = SDI[0]
Bit 1 = SDI[1]
3:0
Bit 2 = SDI[2]
Bit 3 = SDI[3]
These bits are in the resume well and only cleared on a power on reset. Software must
not make assumptions about the reset state of these bits and must set them
appropriately.
Datasheet
High Definition Audio Controller—D27:F0)
0000h
Software must not make assumptions about the reset state of these bits and
must set them appropriately.
High Definition Audio Controller—D27:F0)
0000h
Attribute: R/W
Size: 16 bits
Description
Attribute: R/WC
Size: 16 bits
Description
713