Loopback Interface - Dell PowerConnect M6348 Cli Reference Manual

Loopback Interface

Command
interface loopback
show interface loopback
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 49.
Multicast
Command
ip mcast boundary
ip mroute
ip multicast
ip multicast ttl-threshold
ip pimsm
ip pimsm bsr-border
ip pimsm bsr-candidate
ip pimsm dr-priority
ip pimsm hello-interval
ip pimsm join-prune-interval
ip pimsm register-threshold
ip pimsm rp-address
ip pimsm rp-candidate
ip pimsm spt-threshold
ip pimsm ssm
82
Description
Enters the Interface Loopback configuration mode.
Displays information about configured loopback interfaces. PE
Description
Adds an administrative scope multicast boundary.
Creates a static multicast route for a source range.
Sets the administrative mode of the IP multicast forwarder
in the router to active.
ttlvalue
Applies a to a routing interface.
Administratively enables PIM-SM multicast routing mode
on a particular router interface.
Prevents bootstrap router (BSR) messages from being sent
or received through an interface.
Configures the router to announce its candidacy as a
bootstrap router (BSR).
Sets the priority value for which a router is elected as the
designated router (DR).
Configures the PIM-SM Hello Interval for the specified
interface.
Configures the interface join/prune interval for the PIM-SM
router.
Configures the Register Threshold rate for the RP router to
switch to the shortest path.
Statically configures the RP address for one or more
multicast groups.
Configures the router to advertise itself as a PIM candidate
rendezvous point (RP) to the bootstrap router (BSR).
Configures the Data Threshold rate for the lasthop router
to switch to the shortest path.
Defines the Source Specific Multicast (SSM) range of IP
multicast addresses.
Mode*
GC
Mode*
IC
GC
GC
IC
IC
IC
GC
IC
IC
IC
GC
GC
IC
GC
GC