Dell PowerConnect M6348 Cli Reference Manual page 628

ip route default
Use the ip route default command in Global Configuration mode to configure the default
route. Use the no form of the command to delete the default route.
Syntax
ip route default
no ip route default
next-hop-ip — IP address of the next hop router.
•
preference — Specifies the preference value, a.k.a administrative distance, of an individual
•
static route. (Range: 1-255)
Default Configuration
Default value of preference is 1.
Command Mode
Global Configuration mode
User Guidelines
For routed management traffic:
1. Router entries are checked for applicable destinations.
2. The globally assigned default-gateway is consulted.
Router entries take precedence over an assigned default-gateway.
Example
The following example identifies the
console(config)#ip route 192.168.10.10 255.255.255.0 192.168.20.1
200
ip route distance
Use the ip route distance command in Global Configuration mode to set the default distance
(preference) for static routes. Lower route preference values are preferred when determining the
best route. The ip route and ip route default commands allow optional setting of the distance
of an individual static route. The default distance is used when no distance is specified in these
commands. Changing the default distance does not update the distance of existing static
routes, even if they were assigned the original default distance. The new default distance are
applied to static routes created after invoking the ip route distance command.
628
next-hop-ip preference
[
next-hop-ip preference
[
next-hop-ip
]
]
and a preference value of 200.