Default Configuration
Enabled is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example enables OSPF router mode.
console(config-router)#enable
exit-overflow-interval
Use the exit-overflow-interval command in Router OSPF Configuration mode to configure the
exit overflow interval for OSPF. When a router leaves the overflow state it can originate non-
default AS-external-LSAs. When set to 0, the router will not leave Overflow State until
restarted. Use the no form of the command to return the interval to the default value.
Syntax
exit-overflow-interval
no exit-overflow-interval
seconds — Number of seconds after entering overflow state that a router will wait before
•
attempting to leave the overflow state. (Range: 0–2147483647)
Default Configuration
0 seconds is the default configuration.
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the exit overflow interval for OSPF at 10 seconds.
console(config-router)#exit-overflow-interval 10
seconds
759