Ip Arp Inspection Filter; Ip Arp Inspection Limit - Dell PowerConnect M6348 Cli Reference Manual

Example
console#clear counters ip arp inspection

ip arp inspection filter

Use the ip arp inspection filter command to configure the ARP ACL to be used for a single
VLAN or a range of VLANs to filter invalid ARP packets. If the static keyword is given, packets
that do not match a permit statement are dropped without consulting the DHCP snooping
bindings. Use the "no" form of this command to unconfigure the ARP ACL.
Syntax
ip arp inspection filter
no ip arp inspection filter
acl-name —The name of a valid ARP ACL. (Range: 1–31 characters)
•
vlan-range —A valid VLAN range.
•
Default Configuration
No ARP ACL is configured.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ip arp inspection filter tier1 vlan 2-10 static
console(config)#ip arp inspection filter tier1 vlan 20-30

ip arp inspection limit

Use the ip arp inspection limit command to configure the rate limit and burst interval values
for an interface.
Configuring 'none' for the limit means the interface is not rate limited for Dynamic ARP
Inspection.
NOTE: The maximum pps value shown in the range for the rate option might be more than the hardware
allowable limit. The user needs to understand the box performance and configure the maximum rate pps
accordingly.
acl-name vlan-range
vlan
acl-name vlan-range
vlan
[static]
[static]
225