Dell PowerConnect M6348 Cli Reference Manual page 371

otherwise, all the internal ports in the Group will be brought down. By default, the minimum active
uplinks for a Group is 1, which means at least one uplink port should be active for the Aggregator Group
to be active.
Syntax
minimum active uplinks
number of uplinks — Minimum number of uplinks to be active for the Aggregator Group to be active.
•
(Range: 1-4)
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command has no user guidelines.
Example
console(config)#port-aggregator group 2
console(config-aggregator-2)#minimum active uplinks 2
console(config-aggregator-2)#
mtu disable
Use the mtu disable command to set the mtu size to default (1518) on all the member ports in the
aggregator group/zone. To set the mtu size to the maximum value (9216), use the no form of this
command.
Syntax
mtu disable
no mtu disable
Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
<number of uplinks>
371