Ip Igmp Startup-Query-Count; Ip Igmp Startup-Query-Interval - Dell PowerConnect M6348 Cli Reference Manual

console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp robustness 10

ip igmp startup-query-count

Use the ip igmp startup-query-count command in Interface Configuration mode to set the
number of queries sent out on startup
interface.
Syntax
ip igmp startup-query-count
no ip igmp startup-query-count
count — The number of startup queries. (Range: 1-20)
•
Default Configuration
The default count value is 2.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets for VLAN 15 the number of queries sent out on startup at 10.
console(config)#interface vlan 15
console(config-if-vlan15)#ip igmp startup-query-count 10

ip igmp startup-query-interval

Use the ip igmp startup-query-interval command in Interface Configuration mode to set the
interval between general queries sent at startup on the interface.
Syntax
ip igmp startup-query-interval
no ip igmp startup-query-interval
• seconds — Startup query interval. (Range: 1-300 seconds)
598
at intervals equal to the startup query interval for the
—
count
seconds