Dell PowerConnect M6348 Cli Reference Manual page 792

Example
The following example displays the OSPF Virtual Interface information in the system.
console#show ipv6 ospf virtual-link brief
Area ID
-------
0.0.0.2
timers spf
Use the timers spf command in Router OSPF Configuration mode to configure the SPF delay
and hold time. Use the no form of the command to reset the numbers to the default value.
Syntax
delay-time hold-time
timers spf
no timers spf
• delay-time — SPF delay time. (Range: 0–65535 seconds)
hold-time — SPF hold time. (Range: 0–65535 seconds)
•
Default Configuration
The default value for
Command Mode
Router OSPF Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the SPF delay and hold time.
console(config-router)#timers spf 20 30
792
Hello
Neighbor Interval Interval Interval
-------- -------- -------- ----------
5.5.5.5 10
delay-time
is 5. The default value for
Dead Retransmit
40 5
hold-time
Transit
Delay
--------
1
is 10.