Dell PowerConnect M6348 Cli Reference Manual page 276

Syntax
ip igmp snooping leave-time-out [
no ip igmp snooping leave-time-out
time-out — Specifies the leave-time-out in seconds. (Range: 1 - 3174)
•
• immediate-leave — Specifies that the port should be removed immediately from the members list
after receiving IGMP Leave.
Default Configuration
The default leave-time-out configuration is 10 seconds.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
User Guidelines
The leave timeout should be set greater than the maximum time that a host is allowed to respond to an
IGMP Query.
Use immediate leave only where there is only one host connected to a port.
Example
The following example configures the host leave-time-out to 60 seconds.
console(config-if-1/g1)#ip igmp snooping leave-time-out 60
ip igmp snooping mrouter-time-out
Use the ip igmp snooping mrouter-time-out command in Interface Configuration mode to configure
the mrouter-time-out. This command is used for setting the aging-out time after Multicast router ports
are automatically learned. To reset to the default mrouter-time-out, use the no form of this command.
Syntax
ip igmp snooping mrouter-time-out
no ip igmp snooping mrouter-time-out
time-out — mrouter timeout in seconds for IGMP. (Range: 1–3600)
•
Default Configuration
The default value is 300 seconds.
Command Mode
Interface Configuration (Ethernet, port-channel) mode
276
time-out
| immediate-leave]
time-out