Show Bridge Address-Table; Speed - Dell PowerConnect M6348 Cli Reference Manual

show bridge address-table

Use the show bridge address-table command to show the MAC address table for a particular aggregator
[port-aggregator group <Group id>
group.
specified, it shows all the MAC entries in all the Groups.
Syntax
show bridge address-table
GroupId — Port Aggregator group identifier. (Range: 1-8 or 1-72) On a standalone switch, it is up to 8.
•
On a stack, it is 1 to (6 x<number of units in stack). For a stack of 12 units it is 1-72.
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
console#show bridge address-table port-aggregator group 2
Aggregator Group: 2
Aging time is 300 Sec
Vlan Mac Address
-------- --------------------- ------ --------------------
3 0006.2932.814D
1001 0006.2932.814B

speed

Use the speed command in port aggregator configuration mode to configure the speed of all member
ports in the aggregator group/zone. To restore the default, use the no form of this command.
Syntax
[10 | 100 ]
speed
no speed
374
is an optional parameter in the command, and if not
[port-aggregator group < GroupId >]
Port
1/g2
1/g17
Type
Static
Static