Dell PowerConnect M6348 Cli Reference Manual page 831

Syntax
show ipv6 ospf interface {vlan
vlan-id — Valid VLAN ID.
•
tunnel-id — Tunnel identifier. (Range: 0-7)
•
loopback-id — Loopback identifier. (Range: 0-7)
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
User Guidelines
This command has no user guidelines.
Example
The following example displays the information in VLAN 11's virtual interface tables.
console#show ipv6 ospf interface vlan 11
IP Address..................................... Err
ifIndex........................................ 1
OSPF Admin Mode................................ Enable
OSPF Area ID................................... 0.0.0.0
Router Priority................................ 1
Retransmit Interval............................ 5
Hello Interval................................. 10
Dead Interval.................................. 40
LSA Ack Interval............................... 1
Iftransit Delay Interval....................... 1
Authentication Type............................ None
Metric Cost.................................... 10 (computed)
OSPF Mtu-ignore................................ Disable
OSPF cannot be initialized on this interface.
vlan-id tunnel-id
| tunnel
loopback-id
| loopback }
831