Ipv6 Ospf Hello-Interval; Ipv6 Ospf Mtu-Ignore - Dell PowerConnect M6348 Cli Reference Manual

console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf dead-interval 100

ipv6 ospf hello-interval

Use the ipv6 ospf hello-interval command in Interface Configuration mode to set the OSPF
hello interval for the specified interface.
Syntax
ipv6 ospf hello-interval
no ipv6 ospf hello-interval
seconds — A valid positive integer which represents the length of time of the OSPF hello
•
interval. The value must be the same for all routers attached to a network. (Range: 1-65535
seconds)
Default Configuration
10 seconds is the default value of
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the OSPF hello interval at 15 seconds.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 ospf hello-interval 15

ipv6 ospf mtu-ignore

Use the ipv6 ospf mtu-ignore command in Interface Configuration mode to disable OSPF
maximum transmission unit (MTU) mismatch detection. OSPF Database Description packets
specify the size of the largest IP packet that can be sent without fragmentation on the interface.
When a router receives a Database Description packet, it examines the MTU advertised by the
neighbor. By default, if the MTU is larger than the router can accept, the Database Description
packet is rejected and the OSPF adjacency is not established.
seconds
seconds
.
815