Default Configuration
This command has no default configuration.
Command Mode
Port Aggregator mode
User Guidelines
This command has no user guidelines.
Example
console(config)#port-aggregator group 2
console(config-aggregator-2)#no lacp
console(config-aggregator-2)#
port-aggregator group
Use the port-aggregator group <GroupId> command to enter the Port Aggregator mode to configure
aggregator group attributes. To remove all the attributes on the specified group, use the no form of this
command. The no form of this command deletes all the member ports from the group and also sets
other attributes (mtu/VLAN) to its default values for that group.
Syntax
port-aggregator group
GroupId — Port Aggregator group identifier. (Range: 1-8 or 1-72) On a standalone switch, it is up to 8.
•
On a stack, it is 1 to (6 x < number of units in stack). For a stack of 12 units it is 1-72.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
console(config)#port-aggregator group 1
console(config-aggregator-1)#
<GroupId>
373