Dell PowerConnect M6348 Cli Reference Manual page 972

deny (management)
Use the deny command in Management Access-List Configuration mode to set conditions for
the management access list.
Syntax
deny [ethernet
priority
[priority
deny ip-source
id
| port-channel
• ethernet
vlan-id — A valid VLAN number.
• vlan
• port-channel
ip-address — Source IP address.
•
mask — Specifies the network mask of the source IP address.
• mask
prefix-length — Specifies the number of bits that comprise the source IP address prefix.
• mask
The prefix length must be preceded by a forward slash (/). (Range: 0–32)
• service
tftp, snmp, or sntp.
• priority
Default Configuration
This command has no default configuration.
Command Mode
Management Access-list Configuration mode
User Guidelines
Rules with ethernet, vlan, and port-channel parameters are valid only if an IP address is defined
on the appropriate interface. Ensure that each rule has a unique priority.
Example
The following example shows how all ports are denied in the access-list called
console(config)# management access-list mlist
console(config-macl)# deny
972
interface-number
| vlan
]
ip-address mask
[mask
number
] [service
interface-number — A valid Ethernet-routed port number.
number — A valid routed port-channel number.
service — Indicates service type. Can be one of the following: telnet, ssh, http, https,
priority — Priority for the rule. (Range: 1–64)
vlan-id
| port-channel
prefix-length
| ] [ethernet
service priority
] [priority
number service
] [service
interface-number
| vlan
]
mlist
.
]
vlan-