Dell PowerConnect M6348 Cli Reference Manual page 100

Command
debug ipv6 pimdm
debug ipv6 pimsm
debug isdp
debug lacp
debug mldsnooping
debug ospf
debug ospfv3
debug ping
debug rip
debug sflow
debug spanning-tree
show debugging
*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 49.
sFlow
Command
sflow destination
sflow polling
sflow polling (Interface Mode)
sflow sampling
sflow sampling (Interface Mode)
show sflow agent
show sflow destination
show sflow polling
100
Description
Traces PIMDMv6 packet reception and transmission.
Traces PIMSMv6 packet reception and transmission.
Traces ISDP packet reception and transmission.
Traces of LACP packets received and transmitted by the
switch.
Traces MLD snooping packet reception and transmission.
Enables tracing of OSPF packets received and transmitted
by the switch.
Enables tracing of OSPFv3 packets received and
transmitted by the switch.
Enables tracing of ICMP echo requests and responses.
Enables tracing of RIP requests and responses.
Enables sFlow debug packet trace.
Traces spanning tree BPDU packet reception and
transmission.
Displays packet tracing configurations.
Description
Configures sFlow collector parameters (owner string,
receiver timeout, ip address, and port).
Enables a new sflow poller instance for the data source if
rcvr_idx is valid.
Enable a new sflow poller instance for this data source if
rcvr_idx is valid.
Enables a new sflow sampler instance for this data source if
rcvr_idx is valid.
Enables a new sflow sampler instance for this data source if
rcvr_idx is valid.
Displays the sflow agent information.
Displays all the configuration information related to the
sFlow receivers.
Displays the sFlow polling instances created on the switch. PE
Mode*
PE
PE
PE
PE
PE
PE
PE
PE
PE
PE
PE
PE
Mode*
GC
GC
IC
GC
IC
PE
PE