Gvrp Enable (Interface) - Dell PowerConnect M6348 Cli Reference Manual

Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example globally enables GVRP on the device.
console(config)#gvrp enable

gvrp enable (interface)

Use the gvrp enable command in Interface Configuration mode to enable GVRP on an
interface. To disable GVRP on an interface, use the no form of this command.
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is disabled on all interfaces by default.
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
An Access port cannot join dynamically to a VLAN because it is always a member of only one
VLAN.
Membership in untagged VLAN would be propagated in a same way as a tagged VLAN. In such
cases it is the administrator's responsibility to set the PVID to be the untagged VLAN VID.
Example
The following example enables GVRP on ethernet 1/g8.
console(config)#interface ethernet 1/g8
console(config-if-1/g8)#gvrp enable
266