Dell PowerConnect M6348 Cli Reference Manual page 874

console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel destination 10.1.1.1
tunnel mode ipv6ip
Use the tunnel mode ipv6ip command in Interface Configuration mode to specify the mode of
the tunnel.
Syntax
tunnel mode ipv6ip [6to4]
no tunnel mode
• 6to4 — Sets the tunnel mode to automatic.
Default Configuration
This command has no default configuration.
Command Mode
Interface Configuration (Tunnel) mode.
User Guidelines
This command has no user guidelines.
Example
The following example specifies ipv6ip mode for tunnel 1.
console(config)#interface tunnel 1
console(config-if-tunnel1)#tunnel mode ipv6ip
console(config-if-tunnel1)#tunnel mode ipv6ip 6to4
tunnel source
Use the tunnel source command in Interface Configuration mode to specify the source
transport address of the tunnel, either explicitly or by reference to an interface.
Syntax
tunnel source {
no tunnel source
ipv4addr — Valid ipv4 address.
•
874
ipv4addr vlan-id
| vlan }