Dell PowerConnect M6348 Cli Reference Manual page 506

User Guidelines
This command has no user guidelines.
Example
The following example displays detailed information for unit/port "1/g1."
console#show dvlan-tunnel interface 1/g1
Interface
---------
1/g1
The following table describes the significant fields shown in the example.
Field
Mode
Interface
EtherType
show interfaces switchport
Use the show interfaces switchport command in Privileged EXEC mode to display switchport
configuration.
Syntax
show interfaces switchport {ethernet
Interface — Specific interface, such as ethernet 1/g8.
•
port-channel-number — Valid port-channel trunk index.
•
Default Configuration
This command has no default configuration.
Command Mode
Privileged EXEC mode
506
Mode EtherType
------- --------------
Enable vMAN
Description
This field specifies the administrative mode through which Double VLAN
Tunneling can be enabled or disabled. The default value for this field is
Interface Number.
This field represents a 2-byte hex EtherType to be used as the first 16 bits of the
DVLAN tunnel. The three different EtherType tags are: (1) 802.1Q, which
represents the commonly used value of 0x8100. (2) vMAN, which represents the
commonly used value of 0x88A8. (3) If EtherType is not one of these two values, it
is a custom tunnel value, representing any value in the range of 0 to 65535.
interface port-channel-number
|port-channel
disabled
.
}