Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
The minimum interval cannot be larger than 75% of the maximum interval.
Example
The following example sets the transmission interval between router advertisements at 1000
seconds.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd ra-interval 1000
ipv6 nd ra-lifetime
Use the ipv6 nd ra-lifetime command in Interface Configuration mode to set the value that is
placed in the Router Lifetime field of the router advertisements sent from the interface.
Syntax
seconds
ipv6 nd ra-lifetime
no ipv6 nd ra-lifetime
seconds — Lifetime duration. The value must be zero, or it must be an integer between the
•
value of the router advertisement transmission interval and 9000 seconds. A value of zero
means this router is not to be used as the default router. (Range: 0-9000)
Default Configuration
1800 is the default value for
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example sets at 1000 seconds the value that is placed in the Router Lifetime field
of the router advertisements.
console(config)#interface vlan 15
console(config-if-vlan15)#ipv6 nd ra-lifetime 1000
seconds
.
679