Dell PowerConnect M6348 Cli Reference Manual page 689

show ipv6 mld groups
The show ipv6 mld groups command is used to display information about multicast groups that
MLD reported. The information is displayed only when MLD is enabled on at least one
interface. If MLD was not enabled on any interfaces, there is no group information to be
displayed.
Syntax
show ipv6 mld groups {
group-address — The group address to display.
•
vlan-id — A valid VLAN id.
•
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC mode
User Guidelines
The following fields are displayed as a table when vlan
Number of (*, G) entries
Number of (S, G) entries
Group Address
Interface
Uptime
Expiry Time
vlan-id
If vlan is not specified, the following fields are displayed for each multicast group and
each interface:
Group Address The address of the multicast group.
Interface Interface through which the multicast group is reachable.
Uptime Time elapsed in seconds since the multicast group has been known.
Expiry Time Time left in seconds before the entry is removed from the MLD membership table
of this interface.
group-address vlan-id
| vlan
Displays the number of groups present in the MLD Table.
Displays the number of include and exclude mode sources present in the
MLD Table.
The address of the multicast group.
Interface through which the multicast group is reachable.
Time elapsed in seconds since the multicast group has been known.
Time left in seconds before the entry is removed from the MLD membership
table.
}
vlan-id
is specified:
689