Dell PowerConnect M6348 Cli Reference Manual page 282

Command line interface guide
Hide thumbs Also See for PowerConnect M6348:
Table of Contents

Advertisement

ip igmp snooping maxresponse
This command sets the IGMP Maximum Response time on a particular VLAN. The Maximum
Response time is the amount of time in seconds that a switch will wait after sending a query on an
interface because it did not receive a report for a particular group in that interface. This value must be
less than the IGMP Query Interval time value. The range is 1 to 3174 seconds. The no form of this
command sets the maximum response time on the VLAN to the default value.
Syntax
ip igmp snooping maxresponse
no ip igmp snooping maxresponse
vlan-id — Number assigned to the VLAN.
seconds — IGMP Maximum response time in seconds. (Range: 1-3174)
Default Configuration
The default maximum response time is 10 seconds.
Command Mode
VLAN Configuration mode
User Guidelines
When using IGMP Snooping Querier, this parameter should be less than the value for the IGMP
Snooping Querier query interval.
Example
The following example sets the maximum response time to 60 seconds on VLAN 2.
console(config-vlan)#ip igmp snooping maxresponse 2 60
282
vlan-id seconds
vlan-id

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents