Dell PowerConnect M6348 Cli Reference Manual page 682

ipv6 pimdm hello-interval
The ipv6 pimdm hello-interval command is used to configure the PIM-DM Hello Interval for
the specified router interface. The Hello-interval is to be specified in seconds. Use the "no"
form of this command to reset the hello interval to the default.
Syntax
ipv6 pimdm hello-interval
no ipv6 pimdm hello-interval
• interval - The hello interval time in seconds (Range: 0–65535).
Default Configuration
The default hello interval is 30 seconds.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan5)#ipv6 pimdm hello-interval 500
ipv6 route
Use the ipv6 route command in Global Configuration mode to configure an IPv6 static route.
Syntax
ipv6-prefix
ipv6 route
hop-address
no ipv6 route
id next-hop-address
}]
ipv6-prefix — Is the IPv6 network that is the destination of the static route.
•
prefix-length — Is the length of the IPv6 prefix — a decimal value (usually 0-64) that shows
•
how many of the high-order contiguous bits of the address comprise the prefix (the network
portion of the address). A slash mark must precede it.
• interface — Identifies direct static routes from point-to-point and broadcast interfaces, and
must be specified when using a link-local address as the next hop.
• tunnel or vlan — Is the tunnel or vlan interface to associate with the route.
682
interval
prefix-length
/
preference
[ ]
ipv6-prefix prefix-length
/
preference
[ ]
[Null | interface {tunnel
[Null | interface {tunnel
tunnel-id vlan-id
| vlan
tunnel-id vlan-
| vlan
next-
}]