Dell PowerConnect M6348 Cli Reference Manual page 962

Syntax
ip redirects
no ip redirects
Default Configuration
ICMP Redirect messages are enabled by default.
Command Mode
Interface Configuration (VLAN) mode
User Guidelines
There are no user guidelines for this command.
Example
console(config-if-vlan10)#ip redirects
ipv6 icmp error-interval
Use the icmp error-interval command to limit the rate at which ICMP error messages are sent.
The rate limit is configured as a token bucket with two configurable parameters: Burst-size and
burst interval. Use the "no" form of this command to return burst-interval and burst-size to
their default values. To disable ICMP rate limiting, set burst-interval to zero.
Syntax
ipv6 icmp error-interval
no ipv6 icmp error-interval
burst-interval — How often the token bucket is initialized (Range: 0–2147483647
•
milliseconds).
burst-size — The maximum number of messages that can be sent during a burst interval
•
(Range: 1–200).
Default Configuration
Rate limiting is enabled by default.
The default burst-interval is 1000 milliseconds.
The default burst-size is 100 messages.
Command Mode
Global Configuration mode
962
burst-interval burst-size
[ ]