limit — External LSDB limit for OSPF (Range: -1-2147483647)
•
Default Configuration
limit
-1 is the default value for
.
Command Mode
Router OSPFv3 Configuration mode.
User Guidelines
This command has no user guidelines.
Example
The following example sets the external LSDB limit at 100 for OSPF.
console(config)#ipv6 router ospf
console(config-rtr)#external-lsdb-limit 100
ipv6 ospf
Use the ipv6 ospf command in Interface Configuration mode to enable OSPF on a router
interface or loopback interface.
Syntax
ipv6 ospf
no ipv6 ospf
Default Configuration
Disabled is the default configuration.
Command Mode
Interface Configuration (VLAN, Tunnel, Loopback) mode
User Guidelines
This command has no user guidelines.
Example
The following example enables OSPF on VLAN 15.
console(config)#interface vlan 15
812