Example
The following example sets the OSPF Authentication Type and Key for VLAN 15.
console(config-if-vlan15)#ip ospf authentication encrypt test123
100
ip ospf cost
Use the ip ospf cost command in Interface Configuration mode to configure the cost on an
OSPF interface. Use the no form of the command to return the cost to the default value.
Syntax
integer
ip ospf cost
no ip ospf cost
integer — Specifies the cost (link-state metric) of the OSPF interface. (Range: 1–65535)
•
Default Configuration
10 is the default link-state metric configuration.
Command Mode
Interface Configuration (VLAN) mode.
User Guidelines
This command has no user guidelines.
Example
The following example configures the cost on the OSPF interface at 5.
console(config-if-vlan15)#ip ospf cost 5
ip ospf dead-interval
Use the ip ospf dead-interval command in Interface Configuration to set the OSPF dead
interval for the specified interface. Use the no form of the command to return the interval to the
default value.
Syntax
ip ospf dead-interval
seconds
no ip ospf dead-interval
762