User Guidelines
Lower route distance values are preferred when determining the best route.
Example
The following example sets the default distance to 80.
console(config)#ipv6 route distance 80
ipv6 unicast-routing
Use the ipv6 unicast-routing command in Global Configuration mode to enable forwarding of
IPv6 unicast datagrams.
Syntax
ipv6 unicast-routing
no ipv6 unicast-routing
Default Configuration
Disabled is the default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example globally enables Ipv6 unicast datagram forwarding.
console(config)#ipv6 unicast-routing
console(config)#no ipv6 unicast-routing
ping ipv6
Use ping ipv6 command in Privileged EXEC mode to determine whether another computer is
on the network. To use the command, configure the switch for network (in-band) connection.
The source and target devices must have the ping utility enabled and running on top of TCP/IP .
The switch can be pinged from any IP workstation with which the switch is connected through
the default VLAN (VLAN 1), as long as there is a physical path between the switch and the
workstation. The terminal interface sends three pings to the target station.
684