Dell PowerConnect M6348 Cli Reference Manual page 696

Example
console#show ipv6 mld-proxy groups
Interface................................ vlan 10
Group Address Last Reporter
------------- -------------- ---------- ----------------- ------------ -------
FF1E::1
FF1E::2
FF1E::3
FF1E::4
show ipv6 mld-proxy groups detail
Use the show ipv6 mld-proxy groups detail command to display information about multicast
groups that MLD Proxy reported.
Syntax
show ipv6 mld-proxy groups detail
Default Configuration
There is no default configuration for this command.
Command Mode
Privileged EXEC
User Guidelines
The following parameters are displayed by this command:
Interface
Group Address
Last Reporter
Up Time (in secs)
Member State
Filter Mode
696
Up Time
FE80::100:2.3 00:01:40
FE80::100:2.3 00:02:40
FE80::100:2.3 00:01:40
FE80::100:2.3 00:02:44
The interface number of the MLD-Proxy.
The IP address of the multicast group.
The IP address of the host that last sent a membership report for the current group
on the network attached to the MLD Proxy interface (upstream interface).
The time elapsed in seconds since last created.
Possible values are:
• Idle_Member—The interface has responded to the latest group membership
query for this group.
• Delay_Member—The interface is going to send a group membership report to
respond to a group membership query for this group.
Possible values are Include or Exclude.
Member State Filter Mode
DELAY_MEMBER Exclude
DELAY_MEMBER Include
DELAY_MEMBER Exclude
DELAY_MEMBER Include
Sources
2
1
0
4