Show Lldp Med; Show Lldp Med Interface; Show Lldp Med Local-Device; Show Lldp Med Remote-Device - Dell PowerConnect M6348 Cli Reference Manual

Command

show lldp statistics

lldp med
lldp med transmit-tlv
lldp med faststartrepeatcount
lldp med confignotification

show lldp med

show lldp med interface

show lldp med remote-device

show lldp med local-device

*NOTE: For the meaning of each Mode abbreviation, see "Mode Types" on page 49.

Port Aggregator Commands

Command

add ethernet

duplex

minimum active uplinks

mtu disable

negotiation

no add ethernet
no port-aggregator group

port-aggregator group

show bridge address-table

62
Description
Displays the current LLDP traffic statistics.
Enables/disables LLDP-MED on an interface.
Spwcifies which optional TLVs in the LLDP MED set are
transmitted in the LLDPDUs.
Sets the value of the fast start repeat count.
Enables sending the topology change notifications.
Displays a summary of the current LLDP MED
configuration.
Displays a summary of the current LLDP MED
configuration for a specific interface.
Displays the current LLDP MED remote data.
Displays the advertised LLDP local data.
Description
Adds member Ethernet port(s) to the Aggregator Group.
Configures the full/half duplex operation of all member
ports in the aggregator group/zone.
Sets the minimum number of uplinks to be active for the
Group.
Sets the mtu size to default (1518) on all the member ports
in the aggregator group/zone.
Enables auto-negotiation of all member ports in the
aggregator group/zone.
Remove member Ethernet port(s) from the Aggregator
Group/Zone.
Deletes all the member ports from the group and also sets
other attributes (mtu/VLAN) to its default values for that
group.
Configures aggregator group attributes.
Shows the MAC address table for a particular aggregator
group.
Mode*
PE
IC
IC
GC
IC
PE
PE
PE
PE
Mode*
PA
PA
PA
PA
PA
PA
GC
GC
PE