Dell PowerConnect M6348 Cli Reference Manual page 504

Example
The following example displays how to add a physical port interface to the group ID of "2."
console(config-if-1/g1)#protocol vlan group 2
protocol vlan group all
Use the protocol vlan group all command in Global Configuration mode to add all physical
interfaces to the protocol-based group identified by
interface associated with it. Each interface and protocol combination can be associated with one
group only. If adding an interface to a group causes any conflicts with protocols currently
associated with the group, this command fails and the interface(s) are not added to the group.
Ensure that the referenced VLAN is created prior to the creation of the protocol-based group
except when GVRP is expected to create the VLAN.
To remove all interfaces from this protocol-based group that is identified by this
the no form of the command
Syntax
protocol vlan group all
no protocol vlan group all
groupid — The protocol-based VLAN group ID, which is automatically generated when you
•
create a protocol-based VLAN group with the vlan protocol group command. To see the
group ID associated with the name of a protocol group, use the show port protocol all
command.
Default Configuration
This command has no default configuration.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to add all physical interfaces to the protocol-based group
identified by group ID "2."
console(config)#protocol vlan group all 2
504
groupid
groupid
groupid
. A group may have more than one
groupid
, use