Gvrp Enable (Global) - Dell PowerConnect M6348 Cli Reference Manual

timer_value — Timer values in centiseconds. The range is 10-100 for join, 20-600 for leave,
•
and 200-6000 for leaveall.
Default Configuration
The default timer values are as follows:
• Join timer — 20 centiseconds
• Leave timer — 60 centiseconds
• Leaveall timer — 1000 centiseconds
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
relationships
The following
• Leave time must be greater than or equal to three times the join time.
• Leaveall time must be greater than the leave time.
Set the same GARP timer values on all Layer 2-connected devices. If the GARP timers are set
differently on Layer 2-connected devices, the GARP application will not operate successfully.
timer_value
The setting must be a multiple of 10.
Example
The following example sets the leave timer for port 1/g8 to 90 centiseconds.
console (config)# interface ethernet 1/g8
console (config-if-1/g8)# garp timer leave 90

gvrp enable (global)

Use the gvrp enable (global) command in Global Configuration mode to enable GVRP globally
on the switch. To disable GVRP globally on the switch, use the no form of this command.
Syntax
gvrp enable
no gvrp enable
Default Configuration
GVRP is globally disabled.
for the various timer values must be maintained:
265