Dell PowerConnect M6348 Cli Reference Manual page 349

Example
The following example displays how to set the interval value to 10 seconds.
console(config)#lldp notification-interval 10
lldp receive
Use the lldp receive command in Interface Configuration mode to enable the LLDP receive
capability. To disable reception of LLDPDUs, use the no form of this command.
Syntax
lldp receive
no lldp receive
Default Configuration
The default lldp receive mode is disabled.
Command Mode
Interface Configuration (Ethernet) mode
User Guidelines
This command has no user guidelines.
Example
The following example displays how to enable the LLDP receive capability.
console(config-if-1/g3)#lldp receive
lldp timers
Use the lldp timers command in Global Configuration mode to set the timing parameters for
local data transmission on ports enabled for LLDP. To return any or all parameters to factory
default, use the no form of this command.
Syntax
lldp timers [interval transmit-interval] [hold hold-multiplier] [reinit reinit-delay]
no lldp timers [interval] [hold] [reinit]
transmit-interval — The interval in seconds at which to transmit local data LLDPDUs.
•
(Range: 5–32768 seconds)
349