Ipv6 Pimsm Rp-Candidate - Dell PowerConnect M6348 Cli Reference Manual

Syntax
ipv6 pimsm rp-address
no ipv6 pimsm rp-address
rp-address —An RP address.
•
group-address — The group address to display.
•
prefixlength — This parameter specifies the prefix length of the IP address for the media
•
gateway. (Range: 1–32)
Default Configuration
There are no static RP addresses configured by default.
Command Mode
Global Configuration mode
User Guidelines
There are no user guidelines for this command.
Example
console(config)#ipv6 pimsm rp-address 2001::1 ff1e::/64

ipv6 pimsm rp-candidate

Use the ipv6 pimsm rp-candidate command to configure the router to advertise itself as a PIM
candidate rendezvous point (RP) to the bootstrap router (BSR). Use the "no" form of this
command to disable the router from advertising itself as a PIM candidate rendezvous point (RP)
to the bootstrap router (BSR).
Syntax
ipv6 pimsm rp-candidate vlan
no ipv6 pimsm rp-candidate vlan
• vlan-id—A valid VLAN ID value.
• group-address— The group address to display.
• prefixlength— This parameter specifies the prefix length of the IP address for the media
gateway. (Range: 1–32)
Default Configuration
The router does not advertise itself as a PIM candidate rendezvous point by default.
rp-address group-address/prefixlength
vlan-id group-address/prefixlength
vlan-id
[ override ]
655