Spanning-Tree Disable - Dell PowerConnect M6348 Cli Reference Manual

Syntax
cost
spanning-tree cost
no spanning-tree cost
cost — The port path cost. (Range: 0–200,000,000)
•
Default Configuration
The default cost is 0, which signifies that the cost is automatically calculated based on port
speed.
• 10G Port path cost — 2000
• Port Channel — 20,000
• 1000 mbps (giga) — 20,000
• 100 mbps — 200,000
• 10 mbps — 2,000,000
Command Mode
Interface Configuration (Ethernet, Port-Channel) mode
User Guidelines
There are no user guidelines for this command.
Example
The following example configures the spanning-tree cost on 1/g5 to 35000.
console(config)#interface ethernet 1/g5
console(config-if-1/g5)#spanning-tree cost 35000

spanning-tree disable

Use the spanning-tree disable command in Interface Configuration mode to disable spanning-
tree on a specific port. To enable spanning-tree on a port, use the no form of this command.
Syntax
spanning-tree disable
no spanning-tree disable
Default Configuration
By default, all ports are enabled for spanning-tree.
475