Dell PowerConnect M6348 Cli Reference Manual page 289

ip igmp snooping querier version
This command sets the IGMP version of the query that the snooping switch is going to send
periodically. The no form of this command sets the IGMP Querier Version to its default value.
Syntax
ip igmp snooping querier version
no ip igmp snooping querier version
number — IGMP version. (Range: 1–2)
•
Default Configuration
The querier version default is 2.
Command Mode
Global Configuration mode
User Guidelines
This command has no user guidelines.
Example
The following example sets the IGMP version of the querier to 1.
console(config)#ip igmp snooping querier version 1
show igmp snooping querier
This command displays IGMP Snooping Querier information. Configured information is
displayed whether or not IGMP Snooping Querier is enabled.
When the optional argument
information:
• Admin Mode — Indicates whether or not IGMP Snooping Querier is active on the switch.
• Admin Version — Indicates the version of IGMP that will be used while sending out the
queries.
• Source IP Address — Shows the IP address that is used in the IPv4 header when sending out
IGMP queries. It can be configured using the appropriate command.
• Query Interval — Shows the amount of time in seconds that a Snooping Querier waits before
sending out the periodic general query
• Querier Timeout — Displays the amount of time to wait in the Non-Querier operational
state before moving to a Querier state.
number
vlan_id
is not used, the command shows the following
289