Hotspot
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Use policy routes with hotspot
When creating policy routes for hotspots, the source address should be set to use the hotspot zone:
WebUI
1. Create a new routing policy. See
2. During configuration, for Source address:
a. For Type, select Zone.
b. For Zone, select hotspot.
3. Click Apply to save the configuration and apply the change.
Command line
1. Create a new routing policy. See
2. During configuration, set the source address type to zone:
(config network route policy 0)> src type zone
(config network route policy 0)>
3. Set the zone to hotspot:
(config network route policy 0)> src zone hotspot
(config network route policy 0)>
4. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
5. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Digi Connect EZ 4/4i User Guide
Configure a routing policy
Configure a routing policy
Hotspot configuration
for instructions.
for instructions.
277