Enable Hotspot Using The Default Configuration - Digi TX54 User Manual

Hotspot

Enable hotspot using the default configuration

The default configuration of the TX54 device's hotspot is:
Hotspot
Bridge
Access points
LAN
To use the default hotspot with click-through authentication, enable the hotspot, the bridge, the
access points, and the LAN.
In additional to enabling the default hotspot configuration, you may also want to:
TX54 User Guide
Default configuration
Name: hotspot
n
Disabled
n
Authentication mode: Click-through
n
IP address: 10.1.0.1/24
n
DHCP server: Automatically enabled
n
DHCP server lease range: 100-250
n
Bandwidth limits:
n
Maximum download speed: 10000 Kbps
l
Maximum upload speed: 10000 Kbps
l
Name: hotspot_bridge
n
Disabled
n
2.4 GHz Wi-Fi access point: Digi Hotspot AP (Wi-
n
Fi) (single-Wi-Fi models)
2.4 GHz Wi-Fi access point: Digi Hotspot AP (Wi-
n
Fi1) (dual-Wi-Fi models)
5 GHz Wi-Fi access point: Digi Hotspot AP (Wi-
n
Fi2) (dual-Wi-Fi models)
Name:
n
Digi Hotspot AP (Wi-Fi) (single-Wi-Fi models)
l
Digi Hotspot AP (Wi-Fi1) (dual-Wi-Fi models)
l
Digi Hotspot AP (Wi-Fi2) (dual-Wi-Fi models)
l
Disabled
n
SSID: Digi Hotspot
n
Encryption: Open (unencrypted)
n
Hotspot access points should be set to open
n
(unencrypted). See Hotspot security
information.
Name: LAN hotspot
n
Disabled
n
Device: hotspot_bridge
n
IP address: 192.168.100.1/30
n
This IP address is not used by the hotspot or the
hotspot's DHCP server. It must be a unique IP
address that is not used elsewhere in your
network.
DHCP server: Disabled
n
The hotspot will use the hotspot's DHCP server
n
rather than the LAN's DHCP server.
Hotspot configuration
for further
290