Table of Contents
Advertisement
Serial port
IX20 devices have a single serial port that provides access to the command-line interface.
Use an RS-232 serial cable to establish a serial connection from your IX20 to your local laptop or PC.
Use a terminal emulator program to establish the serial connection. The terminal emulator's serial
connection must be configured to match the configuration of the IX20 device's serial port. The default
serial port configuration is:
Enabled
n
Serial mode: Remote
n
Label: None
n
Baud rate: 9600
n
Data bits: 8
n
Parity: None
n
Stop bits: 1
n
Flow control: None
n
Configure the serial port
By default, the IX20 serial port is configured as follows:
Enabled
n
Serial mode: Remote
n
Label: None
n
Baud rate: 9600
n
Data bits: 8
n
Parity: None
n
Stop bits: 1
n
Flow control: None
n
To change the configuration to match the serial configuration of the device to which you want to
connect:
WebUI
IX20 User Guide
167
Advertisement
Table of Contents
