Configure A Bridge - Digi IX20W-PR User Manual

Interfaces
ii. Add the appropriate device. For example, to add the Digi AP Wi-Fi access point:
(config network bridge my_bridge)> add device end
/network/wireless/ap/digi_ap
(config)>
5. (Optional) Enable Spanning Tree Protocol (STP).
STP is used when multiple LANs are configured on the same device, to prevent bridge loops
and other routing conflicts.
a. Enable STP:
(config)> network bridge eth2 stp enable true
b. Set the number of seconds that the device will spend in each of the listening and learning
states before the bridge begins forwarding data:
(config)> network bridge eth2 stp forward_delay num
(config)>
The default is 2 seconds.
6. Save the configuration and apply the change
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a bridge

Required configuration items
n A name for the bridge.
Bridges are enabled by default.
n Devices to be included in the bridge.
Additional configuration items
n Enable Spanning Tree Protocol (STP).
To create a bridge:

Web
1. Log into Digi Remote Manager, or log into the local Web UI as a user with full Admin access
rights.
2. Access the device configuration:
IX20 User Guide
Bridging
236