Configure A Bridge - Digi TX54 User Manual

Interfaces
Default value: /network/bridge/lan1
Current value: /network/bridge/lan1
(config network bridge my_bridge)>
ii. Add the appropriate device. For example, to add the Digi AP (Wi-Fi) Wi-Fi access
point:
(config network bridge my_bridge)> add device end
/network/wireless/ap/digi_ap1
(config)>
5. (Optional) Enable Spanning Tree Protocol (STP).
STP is used when multiple LANs are configured on the same device, to prevent bridge loops and
other routing conflicts.
a. Enable STP:
(config)> network bridge lan1 stp enable true
b. Set the number of seconds that the device will spend in each of the listening and learning
states before the bridge begins forwarding data:
(config)> network bridge lan1 stp forward_delay num
(config)>
The default is 2 seconds.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Configure a bridge

Required configuration items
A name for the bridge.
n
Bridges are enabled by default.
Devices to be included in the bridge.
n
Additional configuration items
Enable Spanning Tree Protocol (STP).
n
TX54 User Guide
/network/wireless/ap/digi_ap2
/network/wireless/ap/digi_hotspot_ap1
/network/wireless/ap/digi_hotspot_ap2
Bridging
147