Table of Contents
Advertisement
Interfaces
a. Enable STP:
(config)> network bridge eth2 stp enable true
b. Set the number of seconds that the device will spend in each of the listening and learning
states before the bridge begins forwarding data:
(config)> network bridge eth2 stp forward_delay num
(config)>
The default is 2 seconds.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure a bridge
Required configuration items
A name for the bridge.
n
Bridges are enabled by default.
Devices to be included in the bridge.
n
Additional configuration items
Enable Spanning Tree Protocol (STP).
n
To create a bridge:
WebUI
1. Log into the IX20 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
IX20 User Guide
Bridging
163
Advertisement
Table of Contents
