Table of Contents
Advertisement
20
4.6 Installing the stator
On delivery, the stator has already been installed and is ready for operation.
The antenna segments can be separated from the stator, for example, for
maintenance or to facilitate stator mounting. To stop you modifying the center
alignment of the segment rings opposite the base of the stator, we
recommend that you separate only one antenna segment from the stator.
If your application does not require the stator to be dismantled, proceed as
described in points 2., 6., 7. and 8.
Version with speed measuring system
NOTE
Check the screw connections of the antenna segments (see Fig. 4.5) both
after initial installation and then at regular intervals for correct fit and tighten
them if necessary.
As the speed sensor includes the slotted disc, it is not possible to move the
stator axially over the pre‐assembled rotor. In this case, you should also
comply with Chapter 4.8.
Fig. 4.5: Screw fittings of the antenna segments
HBM
Fan‐type lock washer
T10FM
A0894-5.2 en
Advertisement
Table of Contents
