Setting Up The Zero Point - HBM T10FM Mounting Instructions

T10FM
Fig. 7.2: Switch for changing the frequency output voltage

7.2 Setting up the zero point

You can access two potentiometers by removing the stator cover. You can use
the zero point potentiometer to correct zero point deviations caused by the
installation. The balancing range is a minimum of 400 mV at nominal (rated)
gain. The end point potentiometer is used for compensation at the factory and
is capped with varnish so that it cannot be turned unintentionally.
IMPORTANT
Turning the end point potentiometer changes the factory calibration of
the voltage output.
Fig. 7.3: Setting the voltage output zero point
A0894-5.2 en
5 V 12 V
symmetrical asymmetrical
Pos.2
S1
Pos.1
S2
End point
Zero point
33
HBM