Art Ex Command Error Rap - Xerox VersaLink B7025 Service Manual

016-709 ART EX Command Error RAP

016-709 An ART EX command error occurred during PLW processing.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to GP 10. Disconnect the power cord. Electricity can cause
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Advise the customer to:
a. Switch off parallel bi-directional communication in the printer driver.
b. Set a longer time for Auto Output Time.
c. Change the PC BIOS settings.
d. Use a shorter, genuine, parallel cable.
2. Ensure that all connectors on the ESS PWB,
Ensure all surface mounted modules are securely connected.
3. Reload the software, GP 4.
4. Check the wiring between the ESS PWB,
5. Initialise the hard disk. Refer to dC355
6. Initialize the Sys - System NVM, refer to dC301.
7. Install a new hard disk, PL 3.10 Item
8. If the fault persists, install a new ESS PWB,
Status Indicator RAPs
016-709, 016-710
WARNING
PL 3.10 Item 6 are securely connected.
PL 3.10 Item 6 and the hard disk.
Hard Disk Diagnostics.
2.
PL 3.10 Item 6.
016-710 Delayed Print Fail RAP
016-710 Process conditions for delay print were not met.
Procedure
Ensure that the electricity to the machine is switched off while performing tasks that do
not need electricity. Refer to
death or injury. Moving parts can cause injury.
Perform the steps that follow:
1. Advise the customer to:
a. If secure print, proof print or knowledge storage print is specified, disable them.
b. Reduce the delay print jobs waiting to 100 jobs or less.
2. Ensure that all connectors on the ESS PWB,
Ensure all surface mounted modules are securely connected.
3. Reload the software, GP 4.
4. Check the wiring between the ESS PWB,
5. Initialise the hard disk. Refer to
6. Initialize the Sys - System NVM, refer to dC301.
7. Install a new hard disk, PL 3.10 Item
8. If the fault persists, install a new ESS PWB,
April 2017
2-178 Xerox® VersaLink® B7025/B7030/B7035 Multifunction Printer
WARNING
GP 10. Disconnect the power cord. Electricity can cause
PL 3.10 Item 6 are securely connected.
PL 3.10 Item 6 and the hard disk.
dC355 Hard Disk Diagnostics.
2.
PL 3.10 Item 6.
Launch Issue